Suction Capacity

5 m (15 ft) at sea level. Subtract 1 m (3 ft) for every 1,000 m (3,300 ft) altitude. Pump should be placed as low and as close as possible to the water source. Suction capacity my be further limited by intake pipe friction (or clogged filter).

Intake piping should be 1" or larger.

Filtration Requirement

This pump cannot tolerate dirt. Water must be filtered clear. If water is very dirty, improve the source or consider a different pump.

PV-Direct (non-battery) Requirements

• The rated power of the PV array must exceed pump watts by 20% or more.

• A linear current booster incl MPPT (maximum power point tracking) is already included !

• Solar Tracker (optional) will increase daily yield (40-55% in summer)

Installation

• Pump may be mounted horizontally or vertically.

• Pump must not be submerged

• It may be placed inside a 6" (120 cm) or larger well casing, suspended by a rope

Accessories

• Inline Filter: (10") Uses standard filter cartridges

• Installation Kit includes: Pressure switch, pressure gauge, check, drain and shut-off valves and tank tee.

• Float switch for tank shut off if full.

• Well probe sensor to protect pump from dry-running.

Dimensions

• Pump Unit

• Length: 33 cm (13")

• Weight: 7.0 kg (15 lb)

• Controller

• 260 x 175 x 100 mm (10" x 7" x 4")

• Weight: 1.5 kg (3.6 lb)

Warranty

1 year against defects in materials and workmanship